Barefoot Saddle Pad Inserts - Cellular Rubber Tariff Advisory:
This item may be subject to additional import tariffs, which could result in a higher final cost.
To ensure full transparency and avoid any surprises, please contact us before placing your order for an accurate quote and more information.
Replacement saddle pad inserts for all Barefoot saddle pads. The standard Barefoot inserts are made of a very firm closed cell foam, 1/2" inch thick (12mm thick) that provides excellent support. An excellent insert to add to an existing pad for additional support for heavyweight riders.
Helpful Tip: You should check all your inserts for uneven wear about every 6-12 months and replace them if needed.
Click Here for more information on shimming your saddle through the pad!
When should I use additional padding in the saddle pad?
On a large majority of horses the
Barefoot saddle can be used with a pad without
additional pads inside. The saddle can always adjust itself ideally to
the horse's stage of training etc.
It is important that the saddle lays level on the horse when viewed from
the side, meaning that front and rear gullet should be at the same
height. Also when standing right behind the horse though the saddle
should be in balance.
Therefore,
it can sometimes be necessary to insert an additional piece of
rubberfoam in parts of the pad: i.e. in case the horse is higher at the
croup, you simply use a second layer of padding, whereas a horse with
broad shoulders needs a lift-up in the rear.
In case of questions don't hesitate to contact us: saddle specialists enjoy helping you - always with the well-being of
your horse in mind. In order to evaluate your horse's saddle area,
simply send us a picture of it viewed directly from the side and
standing all four limbs equally with his head in normal position.
|
Inserts 
